Ford Focus 2012 Windshield Washer Fluid Reservoir Cap v3

prusaprinters

<p>I have a Ford Focus 2012 (Hatchback) and after 9+ years of prolonged heat, the windshield wiper tank cap decided to disintegrate. I whipped this up it Fusion 360 and printed it in PETG.</p><p>This cap may fit newer ford(s) vehicles.</p><p><strong>Update 02/23/22:</strong></p><ul><li>Added a jacket to fit around the outside of the wiper tube along with fitting inside, this will prevent the part from spinning.</li><li>Feedback from the community, I adjusted the tolerances for the base to fit inside the wiper base.</li><li>Added 4 additional models, ST Logo, Blank, Standard Wiper, and optional funnel.</li><li>Increase the screw length of the caps</li></ul><p><strong>Update 02/25/22:</strong></p><ul><li>Update the “<strong>FordFocus2012_WindshieldWiper_v3_Base_Revised_v1.stl</strong>” Increased thread tolerances for certain printers.</li><li>Added v2 models if needed.</li></ul><p><strong>Update 03/01/22:</strong></p><ul><li>Fixed thread alignment, simulation was set up incorrectly. Logos will align with the notch on the base. See attached photo.<ul><li><strong>Updated files:&nbsp;</strong><ul><li><strong>FordFocus2012_WindshieldWiper_v3_Cap_Revised_v2.stl</strong><br><strong>FordFocus2012_WindshieldWiper_v3_Ford_ST_Logo_Cap_Revised_v2.stl</strong></li></ul></li></ul></li><li><img class="image_resized" style="width:50%;" src="https://media.prusaprinters.org/media/prints/40861/rich_content/8e217249-a507-4658-856a-796e7f2a76b4/alignment.jpg#%7B%22uuid%22%3A%22e8370eb5-d6ab-4f86-a725-3734eb7d1ae6%22%2C%22w%22%3A634%2C%22h%22%3A615%7D"></li></ul><p><strong>Update 03/24/22:</strong></p><ul><li>Updated the funnel to be a little thinner and use less material <strong>FordFocus2012_WindshieldWiper_v3_Optional_Revised_v2.stl</strong></li><li><img class="image_resized" style="width:60.88%;" src="https://media.prusaprinters.org/media/prints/40861/rich_content/c0e37237-8a33-4b29-9bf1-ad0ed8f62d79/funnel.jpg#%7B%22uuid%22%3A%22350aabee-4dc3-48c2-b9bb-54f247d6ad96%22%2C%22w%22%3A824%2C%22h%22%3A575%7D"></li></ul><p><strong>Note:</strong> Best to install when the car is warm. Also, v2 parts are not compatible with v3, I had to rebuild the threads.</p><h3>Print Settings</h3><p><strong>Rafts:</strong> No</p><p><strong>Supports:</strong> No</p><p><strong>Resolution:</strong> 0.2</p><p><strong>Infill:</strong> 20</p><p><strong>Filament:</strong> FilamentOne PETG&nbsp;<br><strong>Notes:</strong></p><p>No support is needed.</p>