Foot Pedal Case for Kailh Big Switch

thingiverse

This was a project for a class. I wanted to make a foot pedal housing anyway so here it is. Works for the kailh big switch keyswitches. Theres a hole in the bottom for running wires through it. Right now there isnt a spot for an arduino since I have it connected to my other macropad. There are two models, one with longer rear legs and one with shorter legs. I usually print them with the square opening facing up, but you will need to use support roof and your support angle to support any overhangs. The legs tend to be very lightly attached to the bed if you don't get good connection between the legs and support.