Foot ends for 4040 V Slot Extrusion - Cable Management Hax

thingiverse

I'm a bit neurotic about keeping my 3D printing setup organized and wanted to stash my endstop and extruder wiring in the middle channel of my Big Delta's 4040 V-slot frame. To accomplish this, I designed these custom feet to attach to the bottom of my 4040 verticals: they raise the printer slightly off the ground, giving me more room to install power supplies, electronics, and wiring; provide access to the center channel for routing wires from the electronics at the bottom to the end stops and extruder components at the top; and reduce the surface area in contact with the carpet, preventing the frame from wobbling. I'm using OpenBuilds 4040 V-slot frames and OpenBuilds low-profile M5 x 30mm bolts along with some M5 washers.