Folgertech FT-6 SOLID Bowden (+dual) extruder mount REMIX

thingiverse

This is an updated design for Blinkingsun's fantastic creation, tailored specifically to the hot side of the FT-6 printer. If you're using the dual bowden hot end on this model, be aware that the mounting holes are spaced 24mm apart, not the usual 18mm. This revised file makes just two key changes: it adjusts the mounting hole spacing and removes the ABL mounting holes altogether. To get the complete print job done, you'll need to visit Blinkingsun's original page and print the remaining parts from there. As per Blinkingsun's detailed instructions: "Print this component with a 0.2mm layer height (including the bottom layer) at 8 top and bottom layers, and 4-layer thick walls with an infill of 25%."