Folgertech FT-6 noise reduction

prusaprinters

<p>This is a kit to help with the noise in the parts in Ft-6 prints</p> <p>The problem I ran into is that the Two motor breakout board for X axis seems to backfeed</p> <p>power between the two motors and adds noise in the print and limits the speed</p> <p>This can cause you to have to have larger than necessary retracts that can lead to jams</p> <p>mod requires a 5 driver board and Blinkingsun's Y carriage so you can run both X motors</p> <p>independently with the makerbot limit switch with m3 hardware</p> <p>The pulleys replace one belt clamp on each of the Y carriage to keep light pressure to damp belt vibration</p> <p>using Flange Ball Bearings 3x10x4mm and m3 hardware</p> <p>Also change X axis pulleys from smooth to 16 toothed ones</p> <p>Please leave a comment after trying any of these mods</p> <p>-Did it help?</p> <p>-Did it fit your printer?</p> <p>-Was it a waste of time?</p> <p>-Was it the fix you needed?</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25</p></div> <p><strong>Filament:</strong> amazon Petg Black</p> </p></p> Category: 3D Printer Accessories