Folgertech FT-6 Hemera Extruder Mount

prusaprinters

<p>I did my best to make a simple mount for the Hemera extruder on the FT-6, but this needs to be done in order to make it successful.</p><p>Step 1, &nbsp;attach the PCB with M3 nuts and M3 x 14mm screws to the back mount with the printed spacers.&nbsp;</p><p>Step 2, release the Y motor screws to give some belt slack. Ziptie the belt on both sides of the back plate the best you can. If you can clap one side it would be better so you can make one more adjustment before making is permanent.&nbsp;</p><p>Step 2, attach the front piece with M3 x 10mm screw to the rail cart.</p><p>Step 3, attach your inductive probe, you'll need a square nut and a M3 x 14mm screw .</p><p>Step 4 attach the from and back on the top with 2 M3 x 10mm screws and 2 square nuts.&nbsp;</p><p>Step 5 Run 4 M3 x45mm screw from the back to the front to mount the Hemera with square nuts.&nbsp;</p><p>Step 6 Make final tension on the belt and tension Y motor. &nbsp;</p><p>&nbsp;</p><p>Fan duct I used. By permanoob https://www.thingiverse.com/thing:4031637</p>