FolgerTech FT-6 Buck Converter Mounting Bracket

cults3d

Buck converter mounting bracket for a FolgerTech FT-6. Requires: • Soldering • (2) M3x12 screws (used to mount bracket to ACM panel • (2) M3x6 button head screws (used to mount buck converter to bracket) • (2) M3 Nyloc nuts You could do away with the need for the M3x12's and the Nyloc nuts by simply using double-sided sticky tape that comes with the machine to mount the bracket to the ACM panel while still utilizing the bracket. Steps (Basic): • Decide where you are going to mount the buck converter while keeping wire lengths in mind. • Use the buck converter bracket as a template to mark the desired mounting location to be drilled (hexagon nut holes) • De-solder plug wires from buck converter • Feed loose plug wires through the front side of bracket through one of the wire slots (either side is fine) and re-solder the plug wires to buck converter inward/facing one another to prevent wire interference with the bracket and the buck converter. • De-solder power lead wires and re-solder orientated inward/facing one another to prevent wire interference in between the bracket and the buck converter. • Feed power lead wires through the front side of bracket from buck converter. • Insert two M3 Nyloc nuts into the hexagon shaped holes (these should fit snug to prevent turning in the holes) • Carefully (at your own risk) screw buck converter to bracket using two M3x6 screws (Do not over tighten) • Guide wires out the ends of the bracket through the provided channels and install bracket to the ACM panel using two M3x12 screws (engaging the Nylocs inside) while being careful to not pinch wires in between bracket and ACM panel or screws. Feel free to shoot me a message if you believe me to have missed a step or would just like more clarification. I intend on making a PDF installation instruction sheet at some point.