Folding Dice Tower

thingiverse

This is my brand new Folding Dice Tower. It collapses down to half its original size, measuring a mere 200mm x 105mm in width and thickness of just 12mm. For gaming enthusiasts, no assembly required, no magnets or clips needed to get it ready to roll. Some essential materials are required beyond the files provided here: Filament 1.75mm works perfectly as welding filler rods do. It's a bit snugger and not as smooth, but still performs great. Time will tell how well it holds up. If your print isn't precise enough, the filler rods will serve you better. Test how well filament fits on the hinges – they must move smoothly. Welding filler rods 1.6mm (I used stainless steel) are needed: * 1 x 150mm (front hinge) * 5 x 190mm (sides and back hinges) * 9 x 30mm (board hinges) If you prefer to use setscrews, I recommend M2.3x3, but hot glue or a print pen will also do the trick. For lining the inside pockets, they're 2mm deep, so any material thinner than 2mm will work just fine. I highly recommend using EVA foam for this purpose. Check out the instruction video on how to assemble it.