Foldable Punisher Phone Stand

prusaprinters

<p>A foldable phone stand that is fully printable.</p> <p>This prints fully assembled.</p> <ul> <li>Print</li> <li>Fold and use</li> </ul> <p><em>203.7mm Length x 50mm Width (LxW)</em></p> <h4>Update 4/15 Uploaded file without the new hinge supports. Now fixed.</h4> <h4>Update: Added an improved model that has added supports, a friction latch to hold the stand closed when folded, and additional clearance below the phone cradle.</h4> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>HyperCube Evolution</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>.2 mm</p></div> <p><strong>Infill:</strong></p> <p>20%</p> <p><strong>Filament:</strong></p> 3D Solutech PLA <p>Your choice</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Notes:<br/> The hinge is designed to print reliably at first layer .3mm and a layer height of .2mm. <p>Other print resolutions will work, but check them in the slicer that clearances aren't affected.</p> <p>Since this is printed flat it is a large print. (203.7mm Length x 50mm Width)</p> <h4>Updated stand directions</h4> <p>The updated stand should be printed with the slicer supports off.</p> <p>After printing the designed-in supports need to be removed:</p> <ol> <li>At each hinge there are 5 small supports.</li> <li>Two phone cradle supports.</li> <li>Friction latch supports.</li> </ol> <p>These supports are internal and hold the latch in place during printing.</p> <p>(Below are the instructions from my Rose design on freeing the latch from the supports.)</p> <h3>Post-Printing</h3> <p>There are four internal supports for the latch. Two are positioned at the front of the latch near the cradle pass-through opening, and two at the rear.</p> <ol> <li>Fold the base to the center like shown above.</li> <li>Using a small object like a screwdriver gently press the latch down until the click of the front supports breaking away is heard.</li> </ol> <p>To break away the rear supports press the latch in.</p> <p>the latch should now be free to move.</p> </p></div></p></p> Category: Mobile Phone