Foldable Phone Stand

prusaprinters

Foldable phone stand with print-in-place hinges! Three sizes included (small, medium, large).The Small size is designed to hold just about any normal sized smartphone, but not any large or XL phones.The Medium size is designed to hold any phone OR tablet, even large or XL phones.The Large size is designed to be more than enough :)Strength test with a 2021 Macbook Pro 13" was successful.Ported over from Thingiverse (model and photos by jonnig)https://www.thingiverse.com/jonnig/https://www.cherry-labs.com/The original creator has now officially ported his design to PrusaPrinters, which you can find here. I will keep this model available here, just note the original is now available on this website too.  Print instructionsSupportsNoRaftNoInfillRecommended 100% infill. Tested successfully down to 10% infillLayer HeightFor best overall results, use .1mm or .15mmFor strength, .15mm is recommendedTested successfully up to .2mmFilamentIt has been successfully printed with a variety of PLA, ABS, NGEN, PETG and Polycarbonate filaments.Post ProcessingYour printer should be calibrated fairly well before printing. Calibration will affect the hinge quality.After printing, hinges should break away easily (the bottom smaller hinge may be more difficult) and should move without much resistance. Other than that, no post processing is required