Foldable Macbook Pro Stand

thingiverse

Printed on an Ultimaker 2 with a layer height of 0.2mm and an extrusion width of 0.4mm in colorFabb_XT light grey and green. This design was created specifically for my MacBook Pro 15 Inch Retina from 2014. The MBP Stand file can be printed without support, although I chose to include a small line in the middle that could easily be omitted. Both the MBP L Notch and MBP R Slot parts were printed flat on the build plate. The MBP L Notch file can also be printed without support, but keep in mind its 250mm length requires careful placement on the bed. Conversely, the MBP R Slot file necessitates printing with support due to its identical 250mm length, thus demanding accurate positioning on the build plate. After completion of the print job, you will need four M3 O-rings and two M3 x 20 hex screws, as well as two M3 lock nuts inserted into the MBP Stand part.