Focusrite Scarlett 2i2 GEN 1 mount (under desk)

thingiverse

This is a edit of Ziller88's design. His file for 1st gen has the incorrect foot-groove size and would not work with 1st gen devices (Serial number's starting with S) If you don't know what generation your device is, see this link: https://support.focusrite.com/hc/en-gb/articles/208295789-Is-my-Scarlett-interface-a-1st-Gen-2nd-Gen-or-3rd-Gen- I found that his design requires unnecessary support material due to the front bezel screw holes being on those ledges, so I removed them and integrated the holes into the front bezel. The front bezel is widened a few mm so make the joins stronger (before they might snap while removing all the support material). I added some cross bars to make the whole thing overall, more rigid. For best results, print this base down to the bed (as shown in the image). Use tree supports, and put blockers so that the support only touches the bed in front of the print and does NOT touch the print below the supported part of the bezel or block the holes. The cross-bars should NOT need supports. The 2i2's feet are stuck on with adhesive. Ensure that there is at least a 119mm gap between them, and that each of them can fit in a 22mm channel (again see image) This printed well for me and is quite a bit stronger and less likely to break during post-print cleanup.