Focuser Motorlid USB-C

thingiverse

I bought a USB-C Arduino Nano clone (NANO V3 ATMEGA 328 Type-C) for this project and I needed a new motorlid at the right size for the USB-C port, so here it is :) By the way, in my case, the arduino could not fit properly in its case; therefore, I had to change the pins where the motor was attached. Here are the lines of code to change to connect the motor on pins 4 to 7 instead of 3 to 6 (it also moves the remote pins to 8 and 9): \#define BTN_IN 8 \#define BTN_OUT 9 AccelStepper stepper(AccelStepper::FULL4WIRE, 7, 5, 6, 4, false);