Flywoo 1S Firefly Nano Baby Satellite Adapter

thingiverse

I recently purchase a Flywoo Firefly 1S Nano Baby (Deadcat) PNP quadcopter, with the intensions of just adding a Lemon Satellite Receiver to this little quad. The problem I ran into was the spot Flywoo designed into the canopy for the receiver was design for a SPI Frysky, ELRS, and TBS CRSF receivers. When I asked customer service at Flywoo if it would fit a DSMX Satellite Receiver, the answer was yes. Unfortunately, there wasn’t really a spot on this tiny quad for it to actually fit properly. This is the reason I designed this Satellite RX adapter plate. Designed into the plate at the rear are two exit points for the receivers two antennas, this will protect them from being hit accidently by the props. The Sat Adapter Plate & Bottom Antenna Plate are mandatory prints, the third STL file is used to mount a micro Beeper to the existing canopy and is optional to print. Note** Keep in mind if you use the small cavity that Flywoo designed into the canopy for one of the other receivers I mentioned above, (as intended) the beeper mount may not fit in place.**