Flysky Noble NB4 GoPro Style Mount (For FPV Monitor)

thingiverse

I implemented the following updates to the original design that was remixed: 1. I swapped mount for a GoPro-style mount. 2. I added clearance on the bottom plate so it doesn't interfere with the grip under the screen (the original design didn't fit). 3. I added clearance to the top plate mount, allowing the steering wheel to be switched from left to right while the mount is attached. 4. I changed the design to use 2 six-millimeter bolts that are one-twentieth of an inch long and a hundred twenty millimeters in length. 5. I added a thumbscrew from McMaster Carr since regular GoPro mount thumbscrews were too long. Using the GoPro-style mount will enable the mounting of any of the readily available GoPro to 1/4-20 adapters. Most FPV monitors have a 1/4-20 mount on the bottom, so you should be able to use these plates along with the aforementioned adapter and some threaded rod and nuts to mount an FPV monitor directly to your Flysky Noble NB4 radio. The plates are to be attached with two six-millimeter by one-twentieth of an inch long hex head bolts and two six-millimeter knobs or nuts. I suggest buying 130-millimeter bolts and cutting them down so there are no exposed threads. Below are the knobs and bolts I am using, which are currently shown in the model. I also found that even the short GoPro thumb screws were too long, so I used an M5 thumbscrew from McMaster Carr instead. Six-Millimeter Knob (Need 2) https://www.mcmaster.com/2776K62 Six-millimeter by one-twentieth of an inch long hex head bolts (Need 2 and need to cut down approximately ten millimeters) https://www.mcmaster.com/91287A264 M5 x 0.8 mm Twenty Millimeter Long Thumb Screw https://www.mcmaster.com/96016A568-96016A245/ Suggested 1/4-20 Mount (Many available) https://www.ebay.com/itm/1-4-Camera-Plastic-TrIPOD-Mount-Adapter-Long-Screw-for-GoPro-SJ4000-Black/291871906898 Note: You only need to print the top and bottom plate. All other files are for reference. Updated on August 8th, 2020 - Fitment went well but I'm changing the thumb screw. I added thumbscrew and 1/4-20 adapter info. Updated on May 6th, 2020 - Still need to do final assembly & fit check.