FlyingBear Ghost 5 - Direct Drive mount for Micro Swiss Bowden Extruder

prusaprinters

<p>Differently from other direct drive mounts for the Ghost 5 i saw laying around, this accomodates MicroSwiss' dual gear extruder, for i already had upgraded the stock crap one. The two holes on the right half are to accomodate brass hot inserts for M3 screws, in order to fasten an accelerometer like an ADXL345, should you need it with Klipper<br><br>Print the two halves with a tough material, PETG at least, and with good heat deflection if you plan to fully enclose the printer; i used Fiberlogy PCTG for my definitive version. Also, i advise to print them with SX and DX markings facing down, using supports, in order to have clean mating surfaces for the motor and the extruder body.<br><br>Give it at least 2 mm shells where possible and a good amount of infill density, with a tridimensional pattern if possible, just to ensure integrity<br><br>STEP file is attached, you're welcome to improve on it.</p>