FlyingBear Ghost 4S Fan Duct for 50x15 turbofan

thingiverse

This is a fan duct for the FlaingBear Ghost 4S, compatible with turbofans measuring 50x15. Warning: do not set the fan speed higher than 50%. The hotend gets extremely cold and may cause a system error. Using a silicone sock might help, but it's not necessary since the airflow is already very strong at lower speeds. I have repositioned the X-axis endstop on top of the carriage. This modification works perfectly with the regular wire length. You will also need a 50x15 turbofan that runs on 24 volts and a few small screws to complete the installation. To assemble this fan duct, you'll require: 2 x 8mm screws 6 x 2.5mm screws for the X-axis endstop 4 x 2.5mm screws for mounting the rear part of the fan duct 2 x 3mm screws for securing the fan