Flying Wing Pod

thingiverse

This is my initial attempt, so it may not be flawless; you might need to enlarge the motor mount holes, smooth out some areas...etc. If that's okay with you, download away! However, keep in mind that this is far from a polished version. I originally intended to add conards to it, which is why there are forward holes for a spar, but I decided against it. Also note that I accidentally made the distance from the motor mount to the end 200mm, leaving no shaft protruding. So the entire pod file has an extended tail, but the individual tail part is 15mm shorter. I used bearings both for replacing motor bearings and for supporting the shaft at the end of the pod: http://www.ebay.com/itm/251149974179? A 200mm long 3mm shaft can be found here: http://www.ebay.com/itm/321896439905? The pod's walls consist of two 1-layer thick walls, separated by a 3mm gap and 3% infill. Alternatively, you could describe it as 3mm thick hollow walls. Custom Section