Flying extruder bracket for FLSun delta

cults3d

This is a bracket designed specifically for attaching a flying extruder to an FLSun delta. It utilizes the existing hole located on top of the carriage. The original purpose of these holes was likely to adjust endstop switches, but with modern printer firmwares, this functionality has become redundant. The bracket features a 4mm hole intended for extruder attachment - the 3mm OD silicone elastic cord, which can be purchased at your local garden center, will fit snugly when paired with a 2.9mm screw inserted into it. Notably, the same 2.9mm screw will also fit perfectly into the designated hole, while a 3mm bolt may also work effectively. You should consider relocating your endstop switches upwards by a few millimeters to avoid reducing your maximum build height by approximately 5mm. Additionally, you will need to recalibrate your printer after implementing this modification.