Flush Mount USB Holder

prusaprinters

<p>This is a flush mount USB holder I designed for my Ikea Lack enclosure. I use two small USB drives for gcode and they can be easily misplaced. Now, they have an official spot on my Ikea Lack enclosure.</p><p><strong>Assembly:</strong></p><ol><li>Drill a 1 inch (25.4 mm) hole into the desired surface at a minimum depth of ½ inch (~12 mm) If drilling into an Ikea Lack Enclosure, be very careful as the table is mostly hollow. I used a hand turned 1" auger bit and brace to cut a clean hole.</li><li>Apply CA glue to the inside rim of the USB holder and press the holder into the hole.</li><li>Double check that the part is in the desired orientation before the glue has time to set.</li></ol>