Fluke 73 III Wall Mount

thingiverse

This is a custom replacement for the factory kick stand, making this mod fully reversible. To install, simply pop out the device from its yellow rubber case, remove the kickstand, and then insert my kickstand. I've included a separate plug that gets installed in the hole to allow for printing without any supports needed. To ensure a smooth fit, I had to perform a minimal amount of sanding. The plug measures 18mm long, with 9mm inserted into the hole and 9mm extending outwards. This replacement kick stand was printed using PLA+ on a Tevo Tornado at a layer height of 0.2mm with an infill density of 50% or more and two wall layers. While it's strong enough for my use, please note that its thickness is only 2mm, so be careful not to slam it around.