Fluke 175, 177, 179, 77 IV Battery cover

thingiverse

If you are searching a battery cover for Fluke 175 or 177 or 179 or 77 IV^ series you have found what you need! It fit perfectly, I've used brim for 15 lines, layer high 0,2mm, fill25% ( but it is irrilevant ). After eliminated support it fit perfectly with it's house. To print in vertical you must open the file with a slicer (I use CURA), the piece is in horizontal, rotate to see the side with the battery house in front of you, next rotate in vertical position the piece ( snap=ON, 90° ), now rotate again to see the houseof battery in front of you ( like a rectangule ), note the side on the bottom is not aligned with the bed, so you must rotate ( without snap) about 0.9 degrees, to align this side with the bed. Now you will obtain the best print.The printer is setted in vertical position with a little inclination to improve the results.If you have an Anycubic I3 mega S you can use the gcode file directly!Good work!