FLSun Super Racer Dampening Rod Clips

thingiverse

Inspired by MrChilton's Kossel Delta Linear Rod Damper, I developed this damper that will fit the rods on the FLSUN_SR Racer. I added a little flare to them to aesthetically fit the powerhouse that the SR Racer is. The print is straight forward, so no supports or adhesion help necessary. I used gyroid for the infill. I included both the single dampener, and 3x files to make it quick. For a single print, I came in around 7 minutes, for all 3 it was closer to 22. Full print at scale with 100% infill came to about 2g in weight and used .68m of material per dampener. Clip Dampeners in place, there will be an audible click when done correct and will slightly bend the dampener to put full tension on rods. Stating this so that it is not perceived as being to large to fit the rods. As other models have had issues with slippage after extended use, I've found making a ring with electric tape to create a bumper above and before will keep the dampeners from sliding. Appreciate any feedback, as this is my first contribution to the community.