FLSUN SR, QQ, QQ-S, and Q5 Spool Holder

thingiverse

This is a spool holder I remixed from Lopatka's, found at https://www.prusaprinters.org/prints/45153-flsun-qq-qq-s-and-q5-spool-holder While I like his design I felt that it was too long and my spools would slide all the way to the end unnecessarily, so I shortened it. "To install the spool holder, make sure the two hooks are on the bottom and then slide it on over the old metal spool holder. There is a notch cut out inside the print (you can see it in the cutaway on picture 6) that locks the spool holder on the small part of the original metal bracket that is bent up. The two hooks on the new spool holder will then side into the back. There is a guide inside the new spool holder (which can be seen in the cutaway on the last picture) which is on the inside-bottom to help keep the spool holder properly oriented as you slide it in place."