FLSUN Q5 CABLE MANAGEMENT with pulley covers remix

thingiverse

These are remixes of other designs that work seamlessly with the FLSUN Q5 for cable management. All remixed to print smoothly with the FLSUN Q5. *Print cable tubes in vase mode without supports and pulley covers in normal mode with support. I've also uploaded my .gcode, which works perfectly with my Q5 and should work with any Q5 if you prefer just to print it. The first picture shows round tubes up front. I didn't have wires running through because at the time I planned to route everything in the back. The last picture shows what it looks like with the heat bed rotated and all wiring run inside the square tube in the back. Ignore the round pulley cover plate on the left side; I was just testing some things. The round version hides the heat bed wire in the front and power/usb cables in the back. The tubes are measured so that three of them fit just right up front. The back should use two 145mm tubes, then resize the third one to about 125-130mm to compensate for a bend in the cables. The square version is designed to pass all wiring in the back. To make this work, you'll need to rotate the heat bed so that the cable faces the back. I also had to cut the larger white heat bed connector out and splice it back together with a solder seal connector so it would fit in the tube. It should be the same as the round version... two for the back plus adjusting the third for around 125-130mm. At some point, I might make a version large enough to pass the heat bed connector through without modification, but someone will need to test it since I've already altered mine.