Flsun Kossel Plexiglass Enclosure

thingiverse

This is the enclosure I built for my Flsun delta printer (or any other with a vertical span of 680mm and 2020 extrusions). It utilizes nine printed corners and three plexiglass panels; the front panel is secured with magnets. Each corner is fastened with two M5x30mm screws. The two rear panels are held in place by 24 M3x12mm screws. The front panel is secured with six 10mm x 3mm magnets. Print: Three corners at the back, four corners at the front, one corner at the front bottom right, and one corner at the front bottom left.