FLSUN i3 autolevel sensor mount for twin dual extruder sled

thingiverse

This is a FLSUN i3 Plus auto-level sensor Mount for the twin dual extruder sled, and fits on the right hand side as shown using the captive nut system and another nut and bolt (3M). The first iteration was too tight, so I added tolerance. You could also use double-sided tape but mine is really tight without that. I am mounting it directly to the sled. Use some BlueTack to hold a nut onto your finger to get the nuts on if you need to or superglue them to a glove. This is only if you are setting up your printer similar to mine. The printer needed a lot of modding and this is my attempt to get it going. Print the item on the front side and it needs no supports - minimal bridging printed on a 'real' Prusa i3 MK3. I hope this is helpful to you please show a photo of it installed. Printed in PLA 50% infill no supports required.