FLSun Cube Part Cooling Fan
thingiverse
This is a part cooling fan for the FlSun. The original design has only one fan that cools the extruder and the part at the same time, but it doesn't do a good job. This part cooling fan is a complement to the extruder cooling fan that can be found here: https://www.thingiverse.com/thing:3994567 You'll need these parts to install this part cooling fan: o A 5015s radial fan o Two M4 x 20mm screws and nuts (to replace the existing screws) o Two M3 x 22mm screws and nuts o Two M3 x 10mm screws and nuts The part cooling fan is held to the X carriage using two of the screws holding the linear bearing. You will need to use the M4 screws mentioned above. You will need to change the wiring to install the cooling fan, so you'll need to reflash Marlin. It's recommended that you do this for the extruder fan as well. I've connected the board fans along with the extruder fan on port D7. I modified the following parameters in Configuration_adv.h: #define E0_AUTO_FAN_PIN 7 #define EXTRUDER_AUTO_FAN_TEMPERATURE 40 This way, the extruder and board fans run only if the extruder temperature is above 40C, which is a big relief when it's not printing. The part cooling fan is installed on D9. To do this, I modified the following parameters in Configuration_adv.h: #define FANMUX0_PIN 9 While doing this, make sure that THERMAL_PROTECTION_HOTENDS and THERMAL_PROTECTION_BED are enabled in Configuration.h. This object's main web page is: http://www.ctheroux.com/flsun-cube-part-cooling-fan/. You can request the source files on the page listed above.
With this file you will be able to print FLSun Cube Part Cooling Fan with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on FLSun Cube Part Cooling Fan.