Floss 3.0 DJI FPV System Parts

thingiverse

I used these parts to install the DJI FPV System in my Hyperlite Floss 3.0: six-inch arms, as specified by the original designer. You'll need them because when you move the camera forward, you'll require more clearance for the props. My build differs from the original design in that I employed a 4-in-1 ESC, which makes my setup slightly taller. Although I aimed to keep it low, I still needed a 35mm standoff. Here are the items I modified: Bottom Plate (DJI Bottom Plate v4.stl): I remixed the bottom plate to move the Air Unit higher, allowing for more space around the antennas. The holes for the standoff were reduced in size and now securely hold it in place without sliding up and down. A notch was also added to the rear of the plate for easy access to the power cable. Antenna Holder (Foss_3_DJI_antenna_mount v1.stl): I enlarged the hole where the MMCX connector exits the mount, providing more room for it to bend into the DJI Air Unit. Motor Wire Cover (LeadCovers 9mm.stl): This is another remixed file from a different quad that I liked. I made it smaller so it would fit on the Floss 3.0 arms.