Floo3dPrint rc aircraft for the hall. Extremely light

thingiverse

Slow RC aircraft for indoor use or at low wind speeds. The planes are printed at 80% and the hulls at 90% size. Printed with carbon fiber reinforced PLA on a K8200 printer expanded to 20cm x 40cm. The wing halves are glued together using epoxy resin and then covered with ironing foil. The tail and elevator are made from 3mm Depron / Epp, while the hull bar is a 4mm carbon fiber rod. The suspension system consists of a 2mm carbon fiber rod and a 1mm steel rod. A 5gr to 10gr brushless outrunner motor is used, along with a 250mh 2s battery for indoor use or a 500mh 2s battery for outdoor use. The center of gravity is located 3-4cm behind the beginning of the wing. The servos for height and side control weigh between 2-3g. The flight weight ranges from 120g to 180g.