Floating Gear Rack Organizer

thingiverse

Based on a photo I saw on Pinterest. I recreated this floating gear organizer. Including a .STEP for those who want to remix/modify. Printed using PolyMaker PLA+ Satin Black Materials: 1" x 24" Dowel (I used an Oak Dowel from HomeDepot) Oak: https://amzn.to/3Pqof9i Walnut: https://amzn.to/4518A64 7/64 Drill Bit: https://amzn.to/3PnLCjX 8 x ¾ Screw: https://amzn.to/45196kw Hardware to mount to wall: https://amzn.to/3PN2y4I PolyMaker Pla+ Satin Black: https://amzn.to/3PuncoM Instructions: Cut Dowel down to the desired length. I used 24" Print out 2qty of the Drill Guide and attach it to the dowel rod a few inches from the edge. Make sure that the feet are level and lying on a flat surface. Pre Drill the screw holes using a 7/64" Drill bit. This ensures the screws are parallel to each other. Screw in the #8 screw and tighten down using the wall mount as a check to make sure it's a snug fit. Mount on the wall. You need to make sure the mounts are sitting on the dowel screws when you mark the holes for the wall. The second one is a bit trickier but doable. The gear holders just slide onto the dowel. they are a tight fit but flex enough to get into the dowel and should stay fit with friction.