Floater the watertight 3 inch cinewhoop drone

thingiverse

This is a beta version of STLs for Floater 3 inch Cinewhoop Drone. 8x 30mm standoffs with 16x M3 screws are required to assemble the drone. The top and bottom parts must be glued together to ensure water tightness, and the wires must be secured properly using hot glue or another suitable method. After printing the top part, the rim needs to be torn off from the middle section to accommodate the cover. The cover is designed to be sealed using insulation tape. Version 0.2 has been updated with several improvements: The bottom part now features ribs in the ducts for added stability and weight optimization. The top part has undergone weight optimization as well. An optional railing can be installed to mount a battery and GoPro, complete with strap. This design is compatible with version 0.1. For more information on building and designing this drone, please visit the group at https://www.facebook.com/groups/844374872701734/. Recommended filament for printing can be found at https://fiberlogy.com/pl/filamenty/nylon-pa12/. To see the performance of this drone in action, check out the video at https://www.youtube.com/watch?v=awP8rdmuRn0. If you enjoy this project and would like to support it, any donations will be greatly appreciated. The following components were used in the prototype build: FC: Matek F411-mini, Betaflight v4.1 (available at https://www.banggood.com/custlink/K3KKbzMnL7). ESC: Airbot ORI32 (available at https://www.banggood.com/custlink/DDmKszMNoB). Motors: Iflight Xing 1408 3600KV (available at https://www.banggood.com/custlink/Gmm3n2UAif). Props: Gemfan 75mm Ducted (available at https://www.banggood.com/custlink/GvGmNzMnlC). Fpv Cam: Caddx SDR1 (available at https://www.banggood.com/custlink/m3GmAUqs0B). VTX: IRC Tramp HV (available at https://www.banggood.com/custlink/KGKvAzzQL9). Tx/Rx: FrSky XM+ (available at https://www.banggood.com/custlink/vvGGAzkQ0W). HD Cam: GoPro Hero7 Black.