Flitetest Tiny Trainer Fuselage

thingiverse

This is a complete fuselage replacement for the Flitetest Tiny Trainer. The nose of the plane is two inches shorter than usual but still has plenty of room to accommodate batteries. After thoroughly testing this design, I achieved outstanding results in flight. To assemble this model, parts should be carefully bonded together using CA glue. A small hole is provided on the hatch for attaching a magnet. To produce high-quality prints, follow these settings: 1. Perimeter shells only 2. Two top layers and two bottom layers with 5% infill density 3. The firewall requires three perimeter shells and 20% infill density 4. The cowling should be printed with three top layers, two bottom layers, and 10% infill density Note that these settings result in a slightly heavier plane but the difference is negligible.