Flirc Bracket

thingiverse

I needed to mount my Flirc case inverted and wanted to easily remove/ install it so I designed this bracket / cradle. Consideration was taken to let the Flirc case radiate. Slide the Flirc case in through the open end of the bracket. The lugs at the top of the side walls bend out of the way and snap the case to a snug fit. Print flat (Screw holes to bed) Wall thickness 2mm (it's quicker than 100% infill). No supports needed. Use PETG or a good quality PLA with some flex. Just over 3 hours print time at 0.2 res @ 55mm/s No brim or raft Req'd.