Flipsky VX1 Remote Reciever Cover [ PPM&UART ]

thingiverse

A Version for connecting via PPM Cable has been added. I swiftly designed a Case for the Flipsky VX1 Remote Receiver because its 90-degree angle makes it feel quite fragile. The recommended orientation is on its side. To install it, simply take the JST/UART connector and feed it through the bottom. However, it's likely to crack in its current state due to insufficient space. It may have cracked solely due to the 0.4mm resolution. A higher resolution might prevent the crack entirely. The crack is extremely minor and won't compromise the structural integrity at all. Maybe dremel a slot in the back so the wires can fit in without causing any cracks. I performed a test print with 0.4mm, and it seemed sufficient to me. The Bottom is open but comes with a lid that needs to be either taped on or glued like I did. The Cover also features an Anti-Disconnect roof for the cables, so if something happens and the connector loosens, it won't disconnect due to the roof preventing it.