Flipper Zero - Wi-Fi Dev Board Case with MicroSD and Removable Antenna

thingiverse

Hello Interwebathons! **Remixed from fivesixzero's original design (which was great!) located here:** https://www.printables.com/model/179910-case-for-flipper-zero-wi-fi-module-v1 You will need to modify the ESPRESSIF board to have the antenna connector, which means you will need to be able to SMT solder and have a steady hand. You will also need to install and wire & solder on a MicroSD Board. You might damage your board if you don't know what you're doing. This is not intended for use for nefarious or questionable purposes. This is simply a case for your WiFi Developer board, and it's intended that the WiFi Dev Board is used for legal purposes only. Use at own risk. No warranties expressed or implied. Not affiliated with fivesixzero or Flipper Devices in any way. **Print Settings:** Nozzle: 0.40mm Line Width: 0.40mm Layer Height: 0.20mm Infill Density: 30%, Cubic Thin Walls: Yes, down to 20% of original line width Supports: Yes, touching build plate only (for the front pin stabilizer blocks). Material used: PolyLite ASA Orange. **Antenna Used:** Bingfu Dual Band WiFi 2.4GHz 5GHz 5.8GHz 8dBi RP-SMA Male Antenna 15cm 6 inch U.FL IPX IPEX to RP-SMA Female Pigtail Cable https://www.amazon.com/gp/product/B00VE1XH4A **MicroSD Expansion Board Used: ** Adafruit MicroSD Card Breakout Board+ [ADA254] https://www.amazon.com/dp/B00NAY2NAI/ **Screws used** 4 x M3x12 with 4 x M3 nuts, all in a black oxide finish. **As with all my designs, this is provided with no warranties, either expressed or implied, and without any support whatsoever. You're on your own with this.**