Flipper Zero - Minimalist WiFi Dev Board Case (Antenna + GPS + SD)

thingiverse

A minimalistic 3D printable case for the Flipper Zero Wi-Fi Dev Board. There are two variations of this case, a larger XL version and a normal size MD version. The XL version has a larger under-cavity for addons such as a GPS module. The MD version has a smaller under-cavity for minimal wiring. Both versions have antenna and/or Micro SD card slot options.VariationsXL (17.75mm thick), 11mm under-cavity, GPS/additions capable:XL > Fully loaded > Antenna mount > Micro SD card slot (by justcallmekoko):XL_Full.stl | XL_Full.3mfXL > Antenna mount only: XL_Antenna_Only.stl | XL_Antenna_Only.3mfXL > Micro SD card slot only (by justcallmekoko):XL_SD_Only.stl | XL_SD_Only.3mfXL > Barebones > No antenna mount or Micro SD card slot:XL_Bare.stl | XL_Bare.3mfNormal (15mm thick), 8.25mm under-cavity for minimal wiring.MD > Fully loaded > Antenna mount > Micro SD card slot (by justcallmekoko):MD_Full.stl | MD_Full.3mfMD > Antenna mount only:MD_Antenna_Only.stl | MD_Antenna_Only.3mfMD > Micro SD card slot only (by justcallmekoko):MD_SD_Only.stl | MD_SD_Only.3mfMD > Barebones > No antenna mount or Micro SD card slot:MD_Bare.stl | MD_Bare.3mfCover / ButtonsXL/MD > CoverCover.stl | Cover.3mfXL/MD > ButtonsButtons.stl | Buttons.3mfAssemblyThe case is designed to be printed in three parts, a top, buttons for the top, a bottom, and then screwed together using 4 x M3x16mm screws w/ 4 x M3 nuts. Place buttons in the top piece and install upside down so buttons don't fall out.Printing and assembly tipsUsing supports when printing can help with the hex holes.Printing the first layers slower also helps with the hex holes.Print all pieces with 100% infill.When the print is done trim with razor around edges so things fit nicely.Use double sided tape to keep your GPS module in place.Trim your buttons and make sure they slide nicely and stay put when inserted.Trim your hex holes and do not force the screws heads in flush, they should slide in nicely.Be careful not to pinch wires, use black tape to keep things in place if you need to.See more designs on my GitHub here: https://github.com/CodyTolene/3D-PrintingEnjoy!