Flightboard Light - 3d printed Glider

thingiverse

This Thing is NOT for commercial use. You can print it for yourself or your flyingbuddy, but please don´t offer it on any marketplace. It takes a lot of workinghours designing and testing such RC-Planes, so don´t be a D!ck! You can also download the newer Version "Flightboard Plus" on my homepage: https://3d-printz.at/produkt-kategorie/stls/ https://www.youtube.com/watch?v=Jny4Uu3wyDs This is my Flightboard Light - an ultracompact 3D printed Glider, made for beeing carried on your Backpack during Hiking or Biking Adventures. Wingspan: 600mm Takeoff Weight: 220g Structure Weight: 140g Wingload: 26g/dm² CG: 38-40mm Print all Parts with 0% Infill, 1 Perimeter, 0,42-0,45mm Extrusion Width! 2 Bottom, 3 Toplayers, 230C (PLA), 0.25mm Layerheight, some overextrusion, 30% Fan. Deactivate Detect Thin walls! The Canopy has an integrated mechanism (Print in Place) so your Printer has to be calibrated well. Fuselage and Canopy Parts should be printed with 4-5mm Brim for better adhesion, be sure to clean your Printbed properly! A perfect levelled First Layer is important for a clean Finish! This Plane was built with simplicity and budget in mind. Printing can be done on one Single Plate with a Standard Volume of 200x200x200 in one single 20hrs Print. For Assembling you just need your Electronics, some superglue, some CA Hinges and of course an hour of freetime. Before Assembling please watch assembling Video: https://www.youtube.com/watch?v=SFoW04zoZDE It is important not to glue the Stab together with the wing Halfs as the Glue will dry to fast to align them right. Also don´t use any other glue than CA as the Stab could deform. When glueing the Fuselage to the wings make sure to align it with center and put a good amount of glue on every single contact surface! Recommended Electronics: 2x 9mm Servos (example: https://www.der-schweighofer.at/Servo-AMX-Racing-1143HB-Analog-Servo-a263118) 1x 2S 350 mAh LIPO 1x RX