Flight Controller Vibration Dampener Mount 30.5mm

thingiverse

I was a big fan of the original Omnimac 3DR Pixhawk Anti Vibration Mount by GuyMcCaldin, and I actually use it on my plane paired with an Eagletree Vector. However, I prefer to run INav firmware and F3, F4 or F7 boards in my smaller aircraft. The original design was too large for the fuselage of my Stone Blue Airlines Reno Racer, which is currently under construction, so I remixed it to be significantly smaller and accommodate a 30.5mm x 30.5mm flight controller chip. You will still need the dampener balls as in the original design, but I used taller standoffs in the picture than I intend to use; I'm currently out of the shorter ones. I added large holes both under the FC and in the base in case I have to route wires that way, and I plan to glue mine into the airplane, although I left the holes in the base for anyone who prefers to screw it down.