FlexHoox - Pegboard hooks and mounting spacers

thingiverse

# Flexhoox Pegboard hooks and spacer with customizer. Build for pegboards with 10mm holes with a 38mm raster (mid-2-mid). ## Mounting a hook The hooks are mounted by pushing the top part (near arch) into the hole, then bringing the bottom part near the lower hole whiles pushing the whole hook up until the bottom edge slides in. ## Unmounting a hook Push from bottom up, until the hook flexes and the lower part can be pulled out ### Hooks The hooks are adjustable in several ways 1. the lengths they go straight and perpendicular away from the board 1. the bend **radius** (top/inner) they bend up and the **angle** 1. another straight section followed by a round tip FDM Print (my values) - The hooks must be printed on their side to gain maximal strength - PLA - 1.2mm wall thickness - 10% infill - no brim required ### Spacer The spacers are for mounting the pegboard through the pegboard holes instead of the holes at the backside. This can be used to create some distance to the wall, so the boards bridge power outlets or can host LED strips. FDM Print (my values) - PLA - 1.2mm wall thickness - 10% infill - no brim required