Flex3Drive G5 cap with Duet laser sensor

thingiverse

I engineered this to secure the laser sensor firmly in place, integrating it seamlessly into the extruder assembly. This component is the cap only; you'll need to obtain the additional parts from Flex3Drive's website. To install the sensor, utilize two M3 screws - one should be an M3x6 or 8 and the other an M3x12 or 14. The bowden tube that runs through this assembly will require a notch cut out where it passes by the sensor. It's essential to plan your cuts before installing the sensor. For optimal results, I recommend printing at a layer height of 0.1mm with no supports needed.