Fleshlight Vesa Mounting

thingiverse

These are tubes to hold Fleshlights in, mounted to a vesa plate. My idea was to have these 3 and the one for my Handy on the Vesa plate so I could switch from manual (Fleshlight) to automatic (Handy) as I desired to. To do this, you need to have the under desk, centrally installed monitor arm. I have made it so that a simple m8 or smaller bolt nut and washer could be used to add this to a single vesa mounting point on a monitor arm. The monitor arm is recommended to be installed centrally under a desk to be in front of a user, but far back enough to allow a typical desk swivel chair to be tucked back under the desk - Roughly 40 - 45 cm away from edge of desk closest to the user. Care should be taken as when the monitor arm is retracted away, under the desk, for discreet and neat storage, a user could accidentally, hit their knee on the monitor arm or its vesa points, when wheeling themselves in to be closer to the desk. Care should also be taken if using a gas and spring loaded monitor arm as it could suddenly spring up and cause injury or damage to the under panel of the desk as to dent or puncture. This can be avoided by adding at least a 2 kg wrist/ankle weight around the monitor arm end (closest to the vesa points) and also adjusting the monitor arm as necessary to allow for maximum/minimum movement as desired. This keeps the arm in place just as an actual monitor, appropriately weighted, would. The air slot bar allows you to remove the bottom lid from your Fleshlight (that allows airflow / less suction) and remove the air slot bar from the Vesa mount to allow the suction free effect. This could be adjusted with the bottom lid of the Fleshlight if desired. Handy Logo labelling have been used with permission from Alexander, the creator of the Handy. This is fine as long as it is not sold commercially. I do not have a 3D printer at present so have not printed and tested - Please do so yourself and let me know any feedback we can use to develop this further.