Fleks3d ANET A8 Clip

thingiverse

This is a clip to attach the 203x203 Flek3d Bed Plate securely to your ANET A8 3D Printer. It's highly recommended that you print about eight of these clips at once, reserving the two for the home start side until your printer leaves that position or sets Z-home at 5mm to avoid any potential hot end contact with the clip. Print Settings: Printer: ANET A8 Rafts: No Raft Required Supports: No Support Needed Resolution: 0.2 mm Layer Height Infill: 20% Infill Density Notes: I utilized the standard print settings without making any adjustments, as I was utilizing the Fleks3d Bed Plate and didn't require a brim. Design Process: I designed this clip in Tinkercad using standard software settings to ensure compatibility with the ANET A8 printer.