Flatpack Deck holder System

thingiverse

**Update 9/13/2020**: I've uploaded double-depth designs for standard card sizes, including two-tier sides and single and double-width bottoms. The Back and Front for Multi sets use standard back/front designs already available. **Update 5/20/2020**: More multi-row set designs are now live, featuring standard depth three-high side panels and standard size three-wide panels. This allows up to nine decks in a single holder. I've also included a three-high American Mini side panel that can be used with Mini Half panels. The Mini Full panels should fit the same sides as standards. As time passes, I'll add more designs. If you find a configuration not currently available that you'd like to see, leave a comment and I'll do my best to create it. **Update 5/13/2020**: The first multi-row set is now live for standard card sets. This is a two-by-two setup. With this design complete, I can start working on others. For this particular item, print two backs, two bottoms, one front, and three sides (H2). Slide the bottoms through the sides and push them back to lock in place. **Update 5/10/2020**: American Mini cards are now included, with a single row, two-deep standard depth, two-deep half-depth, and three-tier half-depth set available. I'm currently working on more layouts, including multi-row designs such as a four-deck holder that's two-tier. **Update 5/9/2020**: This design has been changed to be a "System" so I can upload extra combinations for players. Included in this update is a three-tier side panel. My next update will focus on American Mini cards, which include sizes like Zombicide and Massive Darkness. From there, I'll start working on multi-row holders, starting with two-by-two then moving to three-by-two. I designed these card holders to make table setup easier for board games and make them collapsible so they don't take up a lot of space when not in use. These designs are set up to hold sleeved cards for each type I create. If you'd like to see other sizes, just leave a comment and I'll do my best to accommodate your request. **Standard Sized Cards** For standard sized cards, I consider 66mm wide "sleeved" as most standard sized cards are roughly 63mm wide. Depending on your printer's calibration, you may end up with anywhere between 65-67mm wide. My standard design is set for 67mm wide inside dimensions. As long as your final product is roughly 66.5mm, it shouldn't be a problem. All parts labeled "Standard" will fit together if you use the same row depth. This might change once I get to multi-row designs. You can currently build two-tier and three-tier standard depth sets using the components available. The Back, Front, and Bottom panels are the same for both sets; just different side panels are needed. **American Mini Cards** Mini card holders are now live, featuring a 2-tie and 3-tier setup. For both sizes, all Bottom, Front, and Back panels are interchangeable. Just choose your side panels accordingly. You could potentially use the three-tier sides for full depth from standard cards, but I found I needed to adjust the height of the holder since mini cards are smaller in height, and while it does work, it's not as optimized. **Assembly** Assembly is straightforward: slot the bottoms into the side panels and then slide in the front/back panels. **Coming Soon** I'm currently working on new multi-row or column designs. A 2x2 setup for standard sized cards is in the works, with plans to carry the design forward to other sizes as well. Just takes me some time.