Flat Mouse Trap

thingiverse

This is an updated version of the flat mouse trap I designed and modeled myself. To build it, you will need a strong rubber band and four screws (about 3 mm in diameter) to secure it to any type of container or wall. One screw also serves as a pivot for the trigger. I printed the trap using Cura at a layer height of 0.16mm, a speed of 60mm/s, and 100% infill since it's so small it doesn't require much filament. I used PLA material to print it upright with a reasonably large brim (10mm) to prevent it from getting knocked over. I'm not sure if the trap will catch a mouse or not because I don't have any mice to test it on, which is why I'm sharing it here for you to try out. Your feedback and suggestions are greatly appreciated. Please note that I've chosen not to allow this design to be modified or used for commercial purposes.