Flashlight Bushing for LED Flashlight Stand

thingiverse

I recently found the bushing sliding downward in the holder whenever I pushed the switch, so I decided to install a flange to prevent that from happening again. From now on, use Rev A with the added flange. Thingiverse design #3612 was created for use with my flashlight, but I quickly discovered that the flashlight itself (an NRA gimme flashlight) was too small to fit in the desk stand clips. This custom bushing has been designed specifically to adapt a small-diameter flashlight to the desk stand. Instructions: To produce the recommended Rev A design: - Print the part as is - Build it on a raft with supports enabled - Set your layer height to 0.2 mm and infill at 30% If you want to create Rev - instead: - Rotate the object by 90 degrees so it builds in cylindrical orientation - Set your layer height to 0.2 mm and infill at 30%