Flashlight

Flashlight

thingiverse

Nice Flashlight, check below for instructions. It's very small and engineered to hold a single 1s lipo instead of batteries. It has a highly specific design tailored to the parts I had available. Instead of using breadboard wires to connect the lipo, you can simply solder the cutoffs from the LEDs to a wire. Print Settings Printer: Anet A6 Rafts: Yes Supports: No Resolution: 0.05 - 0.3 Infill: 10% Notes: Turn the cap for printing with the flat side facing down. The parts fit together quite tightly (especially when printed at 0.2 or even more aggressively), so you can either print the 5p led holder at about 99% infill or sand it until it fits smoothly. Print everything with support everywhere, clean it out thoroughly; you may not see the support initially but there is one in the ring where the light goes in. Post-Printing Lipo placement Insert it like I show on the following picture. Make sure the connector faces towards you when inserted. If not, you'll risk breaking the pins over time.

Download Model from thingiverse

With this file you will be able to print Flashlight with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Flashlight.