Flashforge Glass Bed Corner Bracket

thingiverse

New V2 file added to hold glass plates firmly in place with improved design.\nThe Flashforge Creator and Dreamer corner posts now provide enhanced support for glass plates that are 9" x 6" and 5mm thick (and thicker). This redesign boasts tighter tolerances, a wider base, and sturdier construction to ensure stability with just two corners attached. Shortened corners accommodate 5mm (and larger) borosilicate glass plates perfectly.\nDesigned specifically for smaller plates that fit inside the build plate's boundaries (9" x 6"), these corner posts work in tandem with glass Bed Plates that meet the upgraded kit's standards.\nTo print the design:\nPrint this with ABS plastic to avoid melting since it will make contact with the build plate. Use PLA if you don't have a heated bed, as layer resolution remains at 0.2mm with no supports needed. Printing conditions included a hotend temperature of 230C and 110C on the build plate.\nMaterials required:\nTwo corner brackets\nM3 screws that come installed on your printer bed\nTwo M3 fine thread wingnuts\nOne Z-axis shim\nGlass Bed Plate \nTo install:\nSecurely place corner brackets in their designated spots, tighten them with wignuts. You will need to remove small nuts from the bottom of the glass plate for this installation.\nFor detailed instructions and a video guide, click the link below:http://makersome.com/project/717/\nOrder the complete Glass Bed Upgrade Kit, featuring borosilicate glass plates, at the link below:http://makersome.com/store/glass-bed-upgrade-kit/