Flashforge Finder & Inventor II - Overhead Spoolholder v2.0

thingiverse

## New Improved Design! My previous version is available here: https://www.thingiverse.com/thing:3544710 Update 17/11/2019: Added an alternative spool adapter for ClasOhlson 1kg spools. If you find the small adapter rings slip out too easily, try printing one of this instead. Push it into the middle of the spool. It's a tight fit and runs on the center slot of the axle, just like the original Flashforge spools. ## Overhead Spoolholder for Flashforge Finder & Inventor II - Refined design, slim structure, minimal spool friction. All parts are printable on small printbeds like the Flashforge Finder and Inventor II. Just add a few drops of glue to fasten raiser legs to the main structure. The spoolholder stays firmly in place on top of the printer with no "rocking back and forth." It doesn't rub against the extruder belts either. The axle has slots for original FlashForge 600gr filament spools (center opening 20mm) and Universal Clas Ohlson's 1kg filament spools (center opening 52.8mm), using the provided adapter rings. Spools are kept nicely centered in the rack. The rack can easily accommodate spools up to 80mm wide. You can adapt the setup for other spool dimensions by mixing and matching the adapter rings. ## Recommended Print Settings Main Unit: 0.25 res, 20% infill Raiser : 0.25 res, 10% infill 19mm Axle: 0.12 res, 15% infill Adapter Rings: 0.25 res, 100% infill Single Adapter: 0.30 res, 100% infill (new) - Recommended print settings are also noted in each STL-file. Print the risers lying flat and rotated 45 degrees to fit diagonally on the printbed. Print the main unit standing up. If you make this, I would appreciate it if you uploaded a picture of it! Enjoy! ## Duck Junior Filament Clip Check out my filament clip - a handy accessory for overhead spoolholders that makes changing spools easy and keeps dust away from the extruder: https://www.thingiverse.com/thing:3679772