FlashForge Dreamer Z-axis shim for a 1/4" glass bed(johngiachero SCAD file used)

thingiverse

I thin out enough the Z-axis shim to fit behind my Dreamer 3D printer.\nThe dreamer is a bit cramped inside, which makes this modification necessary. I wanted to install a glass bed in my Dreamer, but the shipped shim didn't seem to have a suitable location.\nCredit goes to johngiachero for his design, and you can visit his THING page to remix it for your specific 3D printer or other glass beds. Instructions: I print this with my Flash Forge Dreamer in 1.75mm blue PLA at .30mm first layer and .20mm rest, three shells, 25% hexagonal infill, 100mm/s print speed, 120mm/s travel speed, 60°C heated Kapton tape bed, and 195-200°C extruder with airflow, using skirt mode on FlashPrint software. I place the shim right under the height sensor for my Z-axis on the build plate support and between my Z-axis supports.